Kenmore 790.99019 - Manual (Page 14)

FEATURE
OVERVIEW
• Arra ng i ng Warmer
Drawer Racks
• Operating & Setting
Warmer Drawer
Controis
Setting Wanner
Drawer Controls
Arranging Warmer (Warm & Ready™) Drawer Rack Positions
The rack can be used in 2 ways:
• In the upright position to allow low profile food items to be placed both under and on
top of the rack {for example, rolls or biscuits on top of the rack and a casserole dish
undemeafrt).
• In the downward position to allow you to place light weight food items and empty
dishware {for example, rolls or pastries and dinner plates) on the rack.
Set the Warmer Drawer Rack in either position as shown below (Fig. 1 ).
The purpose of the Warmer Drawer is to keep hot cooked foods at serving
temperature. Always start with hot food. It is not recommended to heat cold
food in the Warmer Drawer. Ail food placed in the Warmer Drawer should be
covered with a lid or aluminum foil to maintain quality. Do not use plastic
wrap to cover food. Piastic may melt onto the drawer and be very difficult
to clean. Use only utensils and cookware recommended for oven use in the
Warmer Drawer.
^CAUTION I Always use pothoiders or oven mitts when removing food from
the Warmer Drawer as cookware and plates will be hot and you can be burned.
To Set the Control:
The control is used to select the temperature of the Warmer Drawer. It is
located on the control panel. To set the control, push in and turn the knob to
the desired setting. The temperatures are approximate, and are designated by
HI (high), MED (medium) and LO (low).
1. Turn the knob to select the desired temperature setting.
2. For best results, preheat the drawer before adding food. An empty drawer
will preheat in approximately 15 minutes.
3. When done, turn the control to OFF.
Temperature Selection
Recommended Warmer Drawer settings table is shown in Figure 3. if a
particular food is not listed, start with the MED setting. If more crispness is
desired, remove the lid or aluminum foil from the food. Most foods can be kept
at serving temperatures on the MED setting. When a combination of foods are
to be kept warm (for instance, a meat with 2 vegetables and rolls), use the HI
setting. To avoid heat loss, do not open the Warmer Drawer while in use.
Warmer Drawer Indicator Light
The warmer drawer indicator light is located above the warmer drawer control
knob (See Fig. 2). it turns on when the control is set, and stays on until the
control is turned off.
The warmer drawer is inoperable during the self-clean
cycle.
fir:-
in?
..
Figure 2
Warmer Drawer Recommended Food
Settings Table
Food Item Setting
Bacon HI
Hamburger Patties HI
Poultry HI
Pork Chops HI
Fried Foods HI
Pizza HI
Gravies MED
Casseroles MED
Eggs MED
Roasts (Beef, Pork, Lamb) MED
Vegetables MED
Biscuits MED
Roils, hard MED
Pastries MED
Rolls (soft) LO
Empty Dinner Plates LO
Figure 3
14