Feature overview, Removing and repiacing the oven door, General care & cleaning – Kenmore 790.99019 User Manual
Page 33: Éssl
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FEATURE OVERVIEW
•
Cleaning Recommendations for Ceramic Glass Cooktops (cont’d)
•
Care & Cleaning of Stainless Steel
•
Removing & Replacing Oven Door
General Care & Cleaning
BLEACH
_____
éssL¡
m.
**“
4
Do not use the following on the ceramic giass cooktop:
• Do not use abrasive cleaners and scouring pads, such as metal and
some nylon pads. They may scratch the cooktop, making it more
difficult to clean.
• Do not use harsh cleaners, such as chlorine bleach, ammonia or oven
cleaners, as they may etch or discolor the cooktop.
• Do not use dirty sponges, cloths or paper towels, as they can leave soil
or lint on the cooktop which can burn and cause discoloration.
Care and Cleaning of Stainless Steel (Stainless Steel models only)
Some models are equipped with stainless steel exterior parts. Special care and cleaning
are
required for maintaining the appearance of stainless parts. Please refer to the table
provided at the beginning of the
General Care & Cleaning section in this Use & Care
Manual.
Removing and Repiacing the Oven Door
^CAUTION
I The door is heavy. For safe, temporary storage, lay the door flat with the
inside of the door facing down.
To Remove Oven Door:
1. Open the door.
2. Remove screws located on the inside of the oven door near the hinges
A
(one on
each side.)
3. Close the door to the quarter-open position. Grasp the door firmly on both sides and
lift up and off the hinges.
4. To clean oven door, follow the instructions provided in the
General Care & Cleaning
table.
To Replace Oven Door:
1. Be sure the hinge arms are in the quarter-open position. Be careful if pulling the
hinges open by hand. The hinges may snap back against the oven frame and could
pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom
of the door.
3. Hinge arms must go into the range slots evenly. The hinge arms should be inserted
into the bottom corners of the door as far as they can go.
4. Replace the door mounting screws (See A in illustration).
5.
If the door is not in line with the oven frame, remove it and repeat the above steps.
33