Element cleaning/ replacement, Element cleaning and replacement -20, Service and adjustment (cont’d) – Kenmore POWER MISER 153.316555 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Service and Adjustment (cont’d)
Element Cleaning/
Replacement
NOTE: These instructions are written for element cleaning
and element replacement for the lower element. If it is neceS'
sary to clean or replace the upper element, then repeat these
instructions.
To remove the element from your tank in order to clean or
replace it:
1. Before beginning turn “OFF” the electric power supply to the
water heater.
2. Turn off the water supply to the water heater at the water
shutoff valve or water meter.
3. Attach a hose to the water heater drain valve and put the
other end in a floor drain or outdoors. Open the water heater
drain valve. Open a nearby hot water faucet which will relieve
pressure in the water heater and speed draining.
AWARNING
The water passing out of the drain valve may be
extremely hot To avoid being scalded, make sure all con
nections are tight and that the water flow is directed
away from any person.
4. Remove the two screws securing the access panel, and remove
panel.
5. Remove the insulation block to expose the opening.
6. Lift out the tab as shown to unclip the terminal cover from
the thermostat. The terminal cover can now be removed
from the thermostat.
18