Kenmore ELITE W10215709A - Manual (Page 13)

■ Press and hold LOCK for 3 seconds to lock the dispenser.
■ Press and hold LOCK a second time to unlock the dispenser.
The display screen Indicates when the dispenser Is locked.
There will be water In the filter. Some spilling may occur.
Ö 6
locked unlocked
LOCKED UNLOCKED
The water filter status light will help you know when to change
your water filter. When the water filter status display changes
from “GOOD” to “ORDER,” this tells you that It Is almost time to
change the water filter cartridge. Replace the water filter
cartridge when the water filter status display changes to
“REPLACE.” If water flow to your water dispenser or Ice maker
decreases noticeably, change the filter sooner. The filter should
be replaced at least every 6 months depending on your water
quality and usage. To change the filter, see “Water Filtration
System.”
INDICATOR: STATUS:
NEW or GOOD (green) New filter installed
ORDER (yellow) Order filter
REPLACE (red) OR
when water flow decreases
Replace water filter
After changing the water filter, reset the status light by pressing
and holding the FILTER button for 3 seconds. The status light will
change from Replace (red) to New/Good (green) when the system
Is reset.
Style 1
ÄÄ
W replace
PRESS & HOLD
TO RESET
style 2
• GOOD
I» ORDER
mm
REPLACE
Filter Status
ri
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified tor cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Changing the Water Filter
The water filter is located in the base grille below the freezer
compartment door. It is not necessary to remove the base grille
to remove the filter.
1. Remove the filter by pressing the eject button and pulling
straight out on the filter cap.
NOTES:
■ Avoid twisting the cap when removing the filter because
this could cause the cap to come off. If this occurs,
replace the cap and pull the filter straight out.
3.
B
A. Eject button
B. Filter cap
Remove the cap by turning it counterclockwise until it stops.
IMPORTANT: Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
Take the new cartridge out of its packaging and remove the
covers from 0-rings.
A
B
A. Cover
B. O-ring
4. Place the cap (removed in Step 2) on the new filter. Align the
ridge on the cap with the arrow on the filter. Turn the cap
clockwise until it snaps into place.
5.
6 .
7 .
A. Eject button
B. Arrow on filter
C. Ridge on cap
Push the new filter into the opening in the base grille. As the
filter is inserted, the eject button will depress. The eject
button will pop back out when the filter is fully engaged.
Pull gently on the cap to check that the filter is securely in
place.
Flush the water system. See “Flushing the Water System
After Changing Filter.”
13