Drop-in door rails, To remove and replace the rails, To remove and replace the bin parts – Kenmore ELITE W10215709A User Manual
Page 18: To remove and replace the bins, To remove and replace the bin
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Drop-In Door Rails
To Remove and Replace the Rails:
1. Remove the rails by pulling straight up on each end of the rail.
2. Replace the rails by sliding the shelf rail into the slots on the
door and pushing the rail straight down until it stops.
To Remove and Replace the Bin Parts:
1. Press either release button to open the tilt-out portion of the
bin.
To Remove and Replace the Bins:
1. Remove the bin by lifting it and pulling it straight out.
2. Replace the bin by sliding it in above the desired supports
and pushing it down until it stops.
To Remove and Replace the Bin:
1. Remove the bin by lifting it and pulling it straight out.
2. Replace the bin by sliding it in above the desired supports
and pushing it down until it stops.
A. Release buttons
2. To remove the tilt-out portion of the bin, press in on the
curved levers on each side of the bin. Pull up and out.
NOTES:
■ The bin cannot be removed if it is tilted out all the way. Tilt
it only part of the way before pressing the curved levers to
remove it.
■ Clean the parts as instructed in the “Cleaning” section.
A. Curved lever
Reinstall the tilt-out portion of the bin. Be sure it is properly
seated in the bottom of the bin before inserting the curved
levers into position.
Replace the interior parts of the bin.
A. Strainer basket
B. Dividers
C. Strainer mat
18