Howto remove and install the pullout drawer, Refrigerator installation – Kenmore TRIO 795.7757 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REFRIGERATOR INSTALLATION
HOWTO REMOVE AND INSTALL THE
PULLOUT DRAWER
IMPORTANT: To avoid possible injury or product or
property damage, you wili need two people to perform the
following instructions.
1. Removing Pullout Drawer
• Pull the drawer open to full extension. Remove the
lower basket (1) by lifting basket from rail system.
(If you tilt the door, it will be easier.)
Press both hangers with your thumbs to lift it up.
Separate the left and right rail cover
With both hands, hold both sides of the door and pull it
up to separate it from the rails.
■ With both hands, hold the center bar and push it in to let
both rails fitted simultaneously.
Remove the screws(2) of the rail on both sides.
A
CAUTION: When you remove the drawer, do not hold
the handle. If it may come off and it could cause
personal injury.
A
CAUTION: When laying the drawer down, be careful
not to damage the floor or hurt your feet by the sharp
edges on hinge side.
13