Kenmore 2200128 - Manual (Page 21)

■ Additional cleaning tips are listed below:
PART
Outside
COMMENTS
■ Waxing external painted metal
surfaces helps provide rust
protection. Do not wax plastic
parts. Wax painted metal surfaces
at least twice a year using
appliance wax (or auto paste wax).
Apply wax with a clean, soft cloth.
Inside walls
(allow freezer
to warm up so
cloth won’t
stick)
■ To help remove odors, you can
wash with a mixture of warm water
and baking soda (2 tbs to 1 qt [26 g
to .95 L] of water).
Door liners ■ Do not use cleaning waxes,
and gaskets concentrated detergents, bleaches,
or cleaners containing petroleum
on plastic parts.
Plastic parts ■ Do not use paper towels, window
(covers and
panels)
sprays, scouring cleansers or
flammable fluids. These can
scratch or damage material.
Condenser ■ Remove base grille. (See the
coils “Base Grille” section.)
Use a vacuum with an extended
attachment to clean condenser
coils.
Vacuum coils when dusty or dirty.
Coils may need to be cleaned as
often as every other month.
Replace base grille.
NOTE: Not all appliance bulbs will fit your refrigerator. Be
sure to replace the bulb with one of the same size and
shape.
Refrigerator light bulbs
Dispenser area light (on some models):
1. Unplug refrigerator or disconnect power.
2. Reach through the dispenser area to remove the bulb.
3. Replace the bulb with a heavy-duty 10-watt bulb, which
can be purchased from your dealer.
4. Plug in refrigerator or reconnect power.
Light behind control panel:
1. Unplug refrigerator or disconnect power.
2. Reach behind the Control Panel and remove the bulb.
3. Replace the bulb with a 40-watt appliance bulb.
4. Plug in refrigerator or reconnect power.
Crisper light (on some models):
1. Unplug refrigerator or disconnect power.
2. Pull the top of the light shield forward until it snaps free
and lower it until the light bulb is visible.
3. Replace the bulb with a 40-watt appliance bulb.
4. Pull the top of the light shield up over the bulb and snap
it onto the side wall supports.
5. Plug in refrigerator or reconnect power.
To remove light shield for cleaning:
1. Remove the crisper and the crisper cover.
2. Release the bottom of the shield from the lower side
wall supports.
3. Pull the light shield out from above the crisper cover
and wash it with warm water and a liquid detergent.
4. Rinse and dry the cover.
5. Push the light shield up over the bulb and snap it into
the side wall supports.
Freezer light bulbs
Light below the ice bin:
1. Unplug refrigerator or disconnect power.
2. Push in the sides of the light shield and pull down until
the shield snaps free.
21