Kenmore 2200128 - Manual (Page 6)

fi#y li#€
^ I itii
■TlOlili IC
^WARNING AWARNING
>•
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper eiectricai
connection:
Recommended Grounding Method
A 115 Voit, 60 Hz., AC only 15 or 20 ampere fused,
grounded electrical supply Is required. It is recommended
that a separate circuit serving oniy your refrigerator be
provided. Use an outiet that cannot be turned off by a
switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning,
or removing a iight buib, turn the Thermostat Control (or
Refrigerator Control depending on the model) to OFF and
then disconnect the refrigerator from the eiectricai source.
When you are finished, reconnect the refrigerator to the
eiectricai source and reset the Thermostat Controi (or
Refrigerator Controi) to the desired setting.
Electrical Shock Hazard
Disconnect power before removing doors.
Failure to do so can result in death or
electrical shock.
NOTE: Before removing doors, open both doors and
remove base griiie (see the “Base Grille” section).
Tools Needed:
V4-inch hex-head socket wrench and ¥is-inch hex-head
socket wrench.
1. Unpiug refrigerator or disconnect power suppiy.
2. If you have a dispenser (ice or water), disconnect water
iine (behind base grille).
■ Remove hose from clip.
■ Disconnect union nut and slide it back onto tube.
■ Remove metai insert from tube.
■ Remove union nut and spring.
3. Remove ieft top hinge.
■ Remove hinge cover and screws. DO NOT
REMOVE SCREW 1 AS SHOWN IN DIAGRAM.
■ Disconnect wiring plug and both ground wires.
■ Carefully lift door up off bottom hinge. Make sure
you protect water line from damage.