Kenmore OASIS 110.2807 - Manual (Page 4)

IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions,
including the following:
Read all instructions before using the washer.
Do not wash articles that have been previously cleaned
in, washed in, soaked in, or spotted with gasoline,
dry-cleaning solvents, other flammable, or explosive
substances as they give off vapors that could ignite or
explode.
Do not add gasoline, dry-cleaning solvents, or other
flammable, or explosive substances to the wash water.
These substances give off vapors that could ignite or
explode.
Under certain conditions, hydrogen gas may be
produced in a hot water system that has not been used
for 2 weeks or more. HYDROGEN GAS IS
EXPLOSIVE. If the hot water system has not been
used for such a period, before using the washing
machine, turn on all hot water faucets and let the water
flow from each for several minutes. This will release
any accumulated hydrogen gas. As the gas is
flammable, do not smoke or use an open flame during
this time.
I Do not allow children to play on or in the washer. Close
supervision of children is necessary when the washer is used
near children.
! Before the washer is removed from service or discarded,
remove the door or lid.
! Do not reach into the washer if the drum, tub or agitator is
moving.
! Do not install or store the washer where it will be exposed to
the weather.
! Do not tamper with controls.
! Do not repair or replace any part of the washer or attempt any
servicing unless specifically recommended in this manual or in
published user-repair instructions that you understand and
have the skills to carry out.
! See “Electrical Requirements” for grounding instructions.
SAVE THESE INSTRUCTIONS
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
The parts supplied are in the washer basket.
Tools needed for connecting the drain hose and water
inlet hoses:
Tools needed for securing the drain hose and leveling
the washer:
Adjustable or open end
wrench (14 mm)
Level
Wood block
Ruler or measuring tape
Pliers that open to
1 9/i6'' (3.95 cm) Flashlight (optional)
Alternate Parts
Parts listed are available from your local Sears store or Sears
Service Center. For further information, call 1-800-4-MY-HOME*
NOTE: Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Record hose installation or replacement dates for
future reference.
Parts supplied:
B C D
A. Drain hose form
B. Water inlet hoses (2)
C. Flat water inlet hose washers (4)
D. Beaded tie strap
(1-800-469-4663).
If You Have: You Will Need to Buy:
Laundry tub or
standpipe taller
than 96“ (2.4 m)
Sump pump system (if not already
available)
1 “ (2.5 cm)
diameter standpipe 2 " (5 cm) diameter to 1 “ (2.5 cm)
diameter standpipe adapter.
Part Number 3363920 and connector kit
Part Number 285835
Overhead sewer Standard 20 gal. (76 L) 39“ (99 cm) tall
drain tub or utility sink, sump pump and
connectors (available from local
plumbing suppliers)
Floor drain Siphon break. Part Number 285834;
additional drain hose.
Part Number 8318155 and connector kit.
Part Number 285835
Water faucets
beyond reach of fill
hoses
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008