Canon XH A1 - Manual (Page 94)

94
2. Open the menu and select [SIGNAL SETUP]. Select [SDI OUTPUT] and set it to [ON].
3. From the same [SIGNAL SETUP] submenu select [SDI SPEC.]. Select [AUTO] or
[SD LOCKED] to match the video output you wish to use.
4. Close the menu.
Using the COMPONENT OUT Terminal
Select the appropriate component video signal depending on the TV or monitor you connect.
Open the menu and select [SIGNAL SETUP]. Select [COMP. OUT], select a setting option
and close the menu.
Using the HDV/DV Terminal
• When connecting the camcorder to a monitor TV that supports DV, you may need to carry out a procedure
on the TV to recognize the camera. Refer to the instruction manual of the TV or monitor.
2
INPUT
AUDIO
Pr/Cr
Pb/Cb
Y
VIDEO
R
L
Signal flow
STV-290N Stereo Cable (supplied)
Signal flow
Open the terminal cover
green
red
Set the switch to the
A/V1 position
blue
white
red
DTC-1000 Component Video Cable
(supplied)
yellow
3
CV-150F/CV-250F
DV Cable (optional)
6-pin
4-pin
Open the terminal cover