Kenmore 100.90002 - Manual (Page 6)

OPERATING YOUR FOOD PROCESSOR
CONTROLS
When Ihe processor is plugged In, Ihe blue Power light itluminates !o show that the unit is
connected to a powsr source When the base, bowl and cover assembly Is correctly
connected and locked into place, the OFF button Is also ffluminaied blue to show that the
unit Is ready to operate. If the OFF button is not glowing blue, the bowl and cover are not
locked together correctly
PULSE: When the PULSE birtion is pushed and held. It illuraiiiates blus and the Food
Processor operates As soon as you tet go of the button: the Processor shuts off and the
PULSE button light goes ouh Use PULSE tor short processing tasks, such as chopping nuts
raw meats or vegetables This allows you much greater control of the consistency of what
you are processing.
ON: When the ON button Is pushed, it Illuminates blue and the unit will run continuously
The processor will stay on until you push the OFF button .This is good tor less tender food
and (terns that take a while longer to process.
CHOPPING:
1 Lock the Bowl onto the Base as described in Assernbly,
2, Place the Mulllpurpose/Chopping Blade ortto the
CerrterPost (see Fig 4J.
CAUTION:
Blades are sharp. Handle carefully.
3 Place load to be chopped into Bowl. Refer to Food Guide to
prepare food for chopping
4 Lock Bowi Cover Assembly onto Bowl, as described to
Assembly.
3 Lock the Food Pusher into the Movable Loop by rotating
GounteretDckwise until the food pusher's lab is urrder slot
in the movable loop's ltd, then lock food chute lid into the
spring operated slide bulton by pressing down firmly
6 Plug the cord into art electric oullel. The Food Processors power tight iltuminates btue
to shovr it is connscted to a power sourcs, and the OFF button illuminates if base bowl,
and cover assembly are all locked into place
7 Push the ON button to run constantiy. or for better control over consistency, push and
hold PULSE button
8 When finishEd processing;
• If Pulsing, slop pressing butlorr and unit aulomatically stops.
• If you turned processor to ON, push the OFF bulton to stop.
• Allow the mulllpurpose/ahopplng biada to stop rotating