Pioneer SX-209RDS User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTIONS
• Before making or changing the connections, switch off the power switch and disconnect the power cord from the AC outlet.
Connecting the input/output cords
When another stereo component (purchased separately) is con
nected, note the following instructions:
• Connect the plugs properly. Faulty connections can cause noise
and also breakdowns and failures.
• The white terminal is for the left channel and the red terminal
is for the right channel.
Connecting the speaker cords
1 2
Cutter
Twist the strands
Speaker cord
Pull
NOTES ABOUT SPEAKER CONNECTIONS
When connecting to only speakers A or speakers B, use
speakers with a nominal impedance of between 4iTand 16
Q.
If you connect to both speakers A and B, use speakers with
a nominal impedance between 8 H and 32 Q.
Be sure that connections are secure. Check to make sure
that wires do not protrude from their terminals.
Do not allow the speaker cords to become short-circuited.
Damage may result to your unit.
Do not attempt to connect two sets of speakers to a single
side (A or B). When using two sets of speakers, connect
one set to terminals A and the other set to terminals B.
4
<XRB1008>