Connecting the power cord (1), Connecting the system – Pioneer AVIC50S User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting the System
Connecting the power cord (1)
Speed detection circuit lead
Connection method
Vehicle injection computer
Pass the extension cord
and the lead for the
speed detection circuit
through this hole.
Clamp firmly with
needle-nosed pliers.
Note: The position of the speed detection circuit
depends on the vehicle model. For details,
consult the relevant documents from Pioneer.
When making connections for a model not'listed
in those documents or foi- which connection to
the speed detection circuit is too difficult,
connect the separately sold ND-PGl speed pulse
generator to the pink lead.
Note: The position of the parking brake switch
depends on the vehicle model. For details,
consult the vehicle owner’s manual or dealer.
CAR SPEED SIGNAL INPUT
The mobile navigation system is connected here to detect
the distance the vehicle travels. Always connect the vehicle’s
speed detection circuit or the ND-PGl speed pulse
generator, sold separately. Failure to make this connection
will increase errors in the location display.
PARKING BRAKE
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of
the parking brake swich. If this connection is made
incorrectly or omitted, certain functions of your
navigation system will be unusable.
Connection method
Clamp the parking brake
switch power supply side
lead.
Clamp firmly with
needle-nosed pliers.
Ground side
Parking brake switch