Sharp Aquos LC 42D43U - Manual (Page 30)

Basic adjustment settings
:;PQ#ffiG0ritrd|v;::;
Power control setting allows you to save energy.
No signal off
When set to “Enable”, the power will automatically shut
down if there is no signal for 15 minutes.
Press MENU to display the MENU screen, and
then press Mip- to select “Power Control”.
raC I Press A.-'T to select “No Signal Off’, and then
press enter .
Press <■■> to select “Enable”, and then press
ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
Press MENU to exit.
• “Disable” is the factory preset value.
• When a W program finishes, this function may not operate.
No operation off
When set to “Enable”, the power will automatically shut
down if there is no operation for 3 hours.
Press MENU to display the MENU screen, and
then press to select “Power Control”.
Press ^/T to select “No Operation Off”, and
then press ENTER
Press -</►• to select “Enable”, and then press
ENTER.
® Five minutes before the power shuts down, the
remaining time displays every minute.
Press MENU to exit. •
This setting allows you to optimize the settings of
Digital broadcasting.
■I: Audio^ Setup 11: y ;Urrfrrrrr:F'.'.'.'.'.'.'.'.V; l iF: I IF:V.“rrrrrrrr:F:
You can output digital audio to an AV amplifier or
similar device whose DIGITAL AUDIO INPUT terminal
is connected to the DIGITAL AUDIO OUTPUT terminal
on the TV. Please select an audio output format
compatible with the audio format of the program you
are watching and the equipment connected.
Press MENU to display the MENU screen, and
then press to select “Digital Setup”.
Press A/V to select “Audio Setup”
press ENTER.
and then
Press A/T to select “PCM” or “Dolby Digital"
and then press ENTER.
Selejcteditem-
PCM
Dolby Digital
Pescripli.pn t
The optica! output terminal outputs audio
signal in PCM form. If your digital audio
system does not support Dolby Digital,
select “PCM".
The optica! output terminal outputs audio
signal in Dolby Digital form. It reproduces
sound from surround program of digital.
Press MENU to exit.
• “Disable" is the factory preset value.
m - 29