Sharp Aquos LC 42D43U - Manual (Page 52)

Appendix
:;Rem-ovl^g: ite-:StancJ- v ■;::: i!; I'; : v
Before detaching (or attaching) stand, unplug the AC cord from the AC INPUT terminal
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
» Before performing work make sure to turn off the "IT/.
Before performing work spread cushioning over the base area to lay the TV on. This'
damaged.
prevent it from being
-e— Hex key —
Л Ф (i)
ф— — Hex key
Ф
LC-46D43U/LC-52D43U LC-42D43U
® Unfasten the four screws used
to secure the stand in place.
@ Detach the stand from the TV,
(Hold the stand so it will not drop
from the edge of the base area.)
• To attach the stand, perform the above steps in reverse order.
v$ettirigith©.T¥'.on(
The model AN-37AG2 of the wall mount bracket can be used only with LC-42D43U.
• This TV should be mounted on the wall only with the AN-37AG2/AN-52AG1 (SHARP) wall mount bracket. The use
of other wall mount brackets may result in an unstable installation and may cause serious Injuries.
• Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting
that results In accident or injury.
Using an optional bracket to mount the TV
» You can ask a qualified service professional about using an optional AN-37AG2/AN-52AG1 bracket to mount the
TV to the wall.
» Carefully read the instructions that come with the bracket before beginning work. *
Hanging on the wall
AN-37AG2/AN-52AG1 wai! mount bracket.
(See the bracket instructions for details.
About setting the TV angle and height adjustment
For AN-52AG1
Vertical mounting
© Angle of TV 0/5/10/15/20“
© Height
Adjustment
-1 ®Тб4(-5)/0/
+ 1 ®/ g 4( + 5)
• (tan be moved
1 “/б4 (5) up or
down
Unit: inch (cm)
AN-52AG1
* Detach the cable clamps on the rear of the TV when using the optional mount bracket.
m
- 51