Sharp Aquos LC 42D43U - Manual (Page 8)

QUICK REFERENCE
■Attaching: ïheïstàrid.
Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation
LC-46D43U/LC-52D43U
1
Confirm that there are 10 screws
(6
short
screws and 4 long screws) supplied with the TV.
t t f f t f
ÎIÎÎ
of the stand may result in the TV falling over.
® Insert the stand into the openings on the
bottom of the TV.
(2) Insert and tighten the 4 long sorews into
the 4 holes on the rear of the TV.
Attach the two supporting posts for the stand
unit onto the base using the box for the stand
unit as shown below.
(Close-up of the upper side of the stand unit)
i the stand, perform the steps in reverse order.
Short screw
^ Hex key
1 Insert each of the protrusions on the two
supporting posts into the openings on the
upper side of the base.
2 Insert and tighten the 6 short screws with
the hex key (supplied with the product) in the
order of
0
, (
2
) and (
0
.
■ LC-42D43U
i Confirm that there are
8
screws (4 short screws
" ■ ■ and 4 long screws) supplied with the TV.
f f f f t
0 Insert the stand into the openings on the
bottom of the TV.
0 Insert and tighten the 4 long screws into
the 4 holes on the rear of the TV.
0 Set the post for the stand unit onto the box
0 Attach the base to the post.
0 Insert and tighten the 4 short screws into
the 4 holes on the bottom of the base.
Hex key ^
To detach the stand, perform the steps in reverse order.
7