Combi Centre DX 8074 User Manual
Page 16
Press down
firmly on base
Pull Belt
tight
Press down
firmly on base
Pull Belt
tight
Shoulder belt
29
Section 9 - Installing the Car Seat Base with Vehicle Belts
30
Section 9 - Installing the Car Seat Base with Vehicle Belts
LAP ONLY BELT
Select the best position in the vehicle and
position the base at the correct angle. (See
pages 19,20,21 and 24)
Pass the vehicle Lap belt over the front of the
base threading the belt under the routing
lugs, and through the built-in Locking Clip.
Pull the belt tight!
Excess vehicle belt can be passed back
under the routing lugs and through the built-
in Locking Clip.
WARNING: Not all vehicle belts are
suitable for a car seat installation. See
Section 11 for more information on
suitable vehicle belts.
LAP/SHOULDER BELT
Select the best position in the vehicle and
position the base at the correct angle. (See
pages 19,20,21 and 24)
Route the vehicle Lap belt over the front of
the base threading the belt under the routing
lugs, and through the built-in Locking Clip.
Pull the belt tight!
Then pass the shoulder belt back under the
routing lugs and through the Locking Clip.
Maintain the belt tension.
WARNING: Read the information on page
21 about having the car seat too upright or
too reclined.
If it is not possible to install the base at the
correct angle, try a different position or do
not install in the vehicle.