Combi Centre DX 8074 - Manual (Page 19)

This line must be horizontal
This line must be horizontal
Rolled Towel or similar
Vehicle Belts must run in
straight line
35 Section 10 - Installing the Car Seat without the Base 36 Section 10 - Installing the Car Seat without the Base
Decide where in the vehicle to install the car
seat.
Check that the carseat will sit firmly in that
position.
To position the car seat at the correct angle
adjust it until the line on the side labels is
level.
If it is not possible to get the carseat sitting
firmly and level move it to another position in
the vehicle or do not install in that vehicle.
Some models have a rebound bar for
additional stability in the vehicle. Carseats
having this bar must still be positioned as
shown by the line on the label.
ADDITIONAL SUPPORT FOR THE CAR
SEAT
Some vehicle seats do not provide enough
support to hold the car seat up at the required
angle.
If extra support is required a tightly rolled
towel or firm foam roll (pool noodle) can be
used.
WARNING: Not all vehicle belts are
suitable for a car seat installation. See
Section 11 for more information on
suitable vehicle belts.
Any extra support used to hold the car seat
up must not interfere with the Vehicle Belts.