Combi Centre DX 8074 User Manual
Page 17
31
Section 9 - Installing the Car Seat Base with Vehicle Belts
32
Section 9 - Installing the Car Seat Base with Vehicle Belts
BUILT-IN LOCKING CLIP
Always pass the belt holding the Base
through the Locking Clip even when only one
belt is used, e.g. a LATCH or Lap only belt.
Using the Locking Clip will improve the overall
performance of the car seat in a crash.
When the Base is secured with a
Lap/Shoulder Belt both the Lap and Shoulder
belts need to pass through the Locking Clip.
Locking Clip
LATCH or Lap Belt
Locking Clip
Lap Belt
Shoulder
Belt
When installing the base, ensure the bottom
of the base is in contact with the vehicle
seat.
Check that the base is securely held.
If the base moves easily more than 1"
(25mm) to either side, try another position, or
do not use the car seat in the vehicle.