Combi Centre DX 8074 - Manual (Page 23)

43 Section 11 Vehicle Belt Systems 44 Section 11 Vehicle Belt Systems
Combination Lap/Shoulder Belt with Free
Sliding Latch Plate
Pull out on latch plate. If belt slides freely
through latch plate, the Locking Clip
MUST be used .
Some combination lap/shoulder belts with
free sliding latch plates may be converted
into an ìautomatic locking modeî. Always
use the Locking Clip with these belt
systems.
Combination Lap/Shoulder Belt with
Locking Latch Plate
Vehicle seat belts with locking latch plates
normally hold a car seat tightly.
However in some cases, the locking latch
plate on some seat belts may slip and loosen
after being buckled on car seat if positioned
at a certain angle. If this happens, flip the
latch plate over and re-buckle. Test
installation again to see if this works. If not,
move car seat to another seating location.
PASSIVE RESTRAINTS
Lap Belt with Motorized Shoulder Belt
DO NOT use with any car seat.
PASSIVE RESTRAINTS
Lap or Shoulder belt mounted on Front
Door
DO NOT use a car seat in any front seating
location that has belts mounted to the front
doors. Belts will not stay tight when driving.
Front Door