Caterpillar TAURUS 70 - Manual (Page 73)

Turbomachinery Package Specification Taurus 70 Compressor Set and Mechanical Drive
contained in Solar’s Product Information Letter 184 “Order Fulfillment & Documentation
for Oil & Gas Projects.”
18.5.1 Torsional Analysis Report (Optional)
A torsional analysis can be performed on the entire drive train to determine if there are
any significant torsional resonance conditions within
±10% of the operating speed range.
If a resonance condition (interference) is found, then a fatigue analysis is performed to
confirm the resonance will not cause fatigue failure in the shafting.
18.5.2 Lateral Analysis Report (Optional)
A lateral forced response analysis of the driven equipment can be performed to confirm
that any lateral critical speeds aren’t close enough to the operating speed range to cause
lateral vibration problems.
Table 15. Preservation, Installation, and Documentation Specifications
Mechanical Installation Requirements
Mounting
Space Between Units In Multiple-Unit
Installations A Minimum of 2.4 m (8 ft)
Lube Oil Cooler(s)
Top of The Lube Oil Cooler(s) Not Be More Than 9.1 m (30 ft) Above The Bottom
of The Package Frame, See Note a
Total oil volume of “Outgoing and Return” Lines 1282 L (340 gal)
Total Combined Pressure Drop of The Supply
and Return Lines and Lube Oil Cooler(s) Should Not Exceed 345 kPag (50 psig)
Start, Fuel, Lube, Air/Drain System Schematics
Compliance American National Standards Institute (ANSI)
Y32.10
Solar’s Applicable Engineering Specifications
ES 9-4 Interpretation of Drawing Requirements
ES 9-76 Traceability Requirements Critical Parts, Engine and Related Systems
ES 9-414 Leveling and Installing of Package Bases
ES 2231 Standards and Practices for The Design and Installation of Cable Channels and
TC Rated Cables Installed In Class 1, Division 2 Hazardous Areas
Solar’s Applicable Product Information Letters
PIL 097 Package Preservation and Preparation for Shipment
PIL 181 Package Tie-down Options
PIL 184 Order Fulfillment & Documentation for Oil & Gas Projects
Solar’s Applicable Guidelines
TPIM-1010 Package Installation Guidelines – Compressor Sets and Mechanical Drives
Notes :
(a)
This is to prevent oil tank flooding in the event of a drain back.
© 2009 Solar Turbines Incorporated. All rights reserved. TPS70CSMD/309
72