Kenwood TM-451A - Manual (Page 26)

LOCK: +V +U : LOW MID! REV/-------------------- +/.^ O Q O O O O O:
r«
DUP.ij
CO !
Wm O O O
O Wi
ItldO.Cl.O OMB
Ufcy»lM IslIkIM
SARF
. { m m Apo
★ DIM PAG
-¿ii-BEEP DTSS
■ ■ ■ ■ ■ ■ ■ ■ ■ llll ElZi 'V P ^TEP TON E
1 3 5 7 9 OVER
EUD ;!.l« £ff«TOT CTCSS
DUP
Indicates Full Duplex mode is ON {page 91}. Blinks
while accessing Menu A, Full Duplex {page 23}.
®CO
Indicates Carrier-operated Scan Resume is ON
{page 57}. When not visible, Time-operated Scan
Resume is in effect. Blinks while accessing Menu A,
Scan Resume {page 23}.
Indicates S-meter squelch is ON {page 29}. Blinks while
accessing Menu A, S-meter Squelch {page 23}.
® liilkUi
Indicates the squelch is open due to a receive signal or
noise that is greater in strength than the noise squelch
threshold level {page 28}. Also appears when the noise
squelch is set to minimum by turning the SQL control
fully counterclockwise. If using either CTCSS or DTSS,
indicates the squelch is open due to a received signal
that contains a CTCSS tone or DTSS code that matches
the tone or code programmed in your transceiver.
n tip
® ISSOX l O uM
Displays the transmit/receive frequency, frequency step
{page 35}, and Tone frequency {page 52}. Also
displays the available selections when using Menu
Set-up {page 22}. The decimal point blinks while the
transceiver is scanning {page 59}.
19