Kenwood TM-451A - Manual (Page 67)

5 Select Menu B, No. 60.
• The current lower limit appears.
6 Turn the Tuning control, or press microphone [UP]
or [DWN], to select the desired lower limit.
<,|C inn
/V-l. l U u ^ ,
I 3 • 7 • OVER
» I
U LI
7 Exit Menu B.
Note:
► The upper limit is set first above; however, either lower or upper
limit may be set first provided the upper limit is placed in
Menu B, No. 61 and the lower limit is placed in Menu B, No. 60.
► The lower limit must be lower in frequency than the upper limit.
► To reset the limits to their default values, you can do a Partial or
Full Reset {page 46}.
m
Using Programmable Band Scan
1 Select a frequency between the programmed scan
limits. You may also choose a frequency equal to
one of the limits.
• If you select a frequency that is outside the
programmed scan limits, the transceiver will start
Band Scan automatically instead of
Programmable Band Scan.
2 Press [VFO] (1 s), and Scan starts at the
frequency currently displayed.
• The decimal starts blinking to indicate scanning
is in progress.
• The scan direction is the same as last used.
• The default direction is downward in frequency.
3 To reverse the scan direction, turn the Tuning
control, or press microphone [UP]/[DWN].
• Upward scan: Turn Tuning clockwise, or press
microphone [UP].
• Downward scan: Turn Tuning counterclockwise,
or press microphone [DWN].
4 To cancel Programmable Band Scan, press any key
excluding the microphone DTMF keypad keys.
Note: Squelch must be closed for Scan to function {page 28).
60