Champion Manufacturing DH2000 - Manual (Page 19)

11
Operation
Rinse Sentry Operation Mode
The final rinse water temperature must be a minimum of 180ºF/82ºC during the final rinse cycle to ensure
that all wares are sanitized. If for any reason, the hot water temperature in the booster tank cannot provide
this temperature, the dishwasher will enter a Rinse Sentry Mode of operation and extend the cycle time.
The Rinse Sentry changes the Normal Operation Mode as described below:
1. The Rinse Sentry constantly monitors the water temperature inside final rinse booster.
2. If the temperature inside the booster heater falls below 180ºF/82ºC then the Rinse Sentry
will extend the wash cycle time until the booster heater water temperature reaches the proper
temperature.
3. The in-cycle light will remain illuminated during the Rinse Sentry Mode.
4. The RINSE water temperature gauge must be monitored to ensure that a minimum of
180ºF/82ºC is maintained during the rinse cycle.
5. The temperature range for the final rinse water is 180-195ºF/82-91ºC.
6. An extraordinarily long wash cycle may indicate a low incoming water temperature or a
problem with the booster heater operation.
DO NOT REMOVE WARES UNTIL THE FINAL RINSE CYCLE HAS
SANITIZED THE WARES AND THE GREEN CYCLE LIGHT GOES OUT.
Automatic Drain Cycle
The dishwasher can be drained automatically when the dishwasher has completed a normal wash cycle
or whenever the dishwasher is idle.
To drain the dishwasher:
1. Turn the dishwasher Power Switch OFF. The automatic drain valve will open and the machine
will drain.
2. The drain valve will remain open for 10-minutes to allow time to flush the interior with fresh water
during a cleaning operation.
3. When 10-minutes has elapsed the drain, the drain valve will close.
The automatic drain cycle is complete.
NOTE:
The automatic drain cycle can be repeated after 10-minutes by turning the power Switch ON and
immediately OFF. The dishwasher will drain for another 10-minutes and then turn off.