RCA COLOR TV NCJ11 - Manual (Page 6)

ipt
6 , Coanect antenna or cable-TV system.
Most antenna or cable-TV systems can be connected as
show here.
Incoming Cable from Antenna or
Cable-TV Syatem
' Details for connecting a home antenna to your TV are on
page 32.
Details for connecting a cable-TV system to your TV
are on pages 33-34.
' Details for connecting a VCR to your TV are on
pages 37-38.
8. Converge Colors if Necessary.
If you notice colored rings or halos around objects in the
picture, you may need to converge the colors. Over a period
of time, the picture tubes can drift out of alignment due to
normal bumps and vibrations or moving the TV. Details for
converging the colors are on page 15.
9. AutoProgram the TV’s
channel memory. + Bunon
To start the TV autoprogramming
itself, press the
MENU
button
repeatedly to select SETUP MENU
and then press + to display the setup functions. Repeatedly
press
MENU
again to select
AUTOPROGRAM
function,
and then press -i-. Details are on page 24.
6. Attach power cord.
First attach the flat end of the power cord completely into the
connector on the back of your TV, and then plug the other
end into a wall outlet.
7. Thm on TV, adjust the volume, and select a channel.
* Press the TV button on the
Number­
Buttons
0§§E>
o Ф Ф (5
de> »
S=B S>
ÔOÔ "o
25 O
TV
Button
CHANNEL
Buttons
VOLUME
Buttons
remote to turn on the TV.
When using the remote,
remember to point it at the
front of the TV.
• Press the
VOLUME
up or
down button to adjust the
volume to a desired level.
• Press the
CHANNEL
up or
down button to select the next channel in memory. You can
also press two number buttons to select a channel. To select
a 3-digit cable channel (up to channel 128), press and hold
number button 1 until 1- appears on the screen. Then press
the other two numbers. Channels 2-13 were programmed
into the channel memory for you at the factory, so pressing
CHANNEL
up or down stops at these channels only. When
you start the AutoProgramming feature (described in step 9),
your set will automatically scan through all channels and
place only the active channels for your area into its channel
memory.
• Details about using the remote are on page 9-13.
^VidwiMenti
.■Audio Menu
Setup Menu
Xlarm
jChan Label
IParental Ctrl: Off
Chan Ctii: Normal
Autoprogram
You can also add and erase channels from memory as desired.
Press
MENU
repeatedly to select the
SETUP MENU,
then
press + to display the setup functions.
Press MENU repeatedly to select (highlight) the CHAN MEM
function. Select the desired channel number by pressing the
CHANNEL
up or down button or by pressing the two
corresponding number buttons.
06 '
mlAbel
Parertal CM: O f f .
,’OhanCtrl: Normal
•JAutoprogram
Chan Mem: Stored
Irarental Ctrl: Off
‘ChanCtrt: Normal
."Autoprogram___
Chan Mem: Erased
Then press + to add a channel, or press - to erase a channel.
Details are on page 24.