Comtrol FreeWire - Manual (Page 17)

DeviceMaster FreeWire Installation and User Guide: 2000412 Rev. D Configuring the DeviceMaster FreeWire - 17
Using the DeviceMaster FreeWire Installation Wizard
Using the DeviceMaster FreeWire Installation Wizard
The DeviceMaster FreeWire default address is 192.168.250.250. It may be
necessary to change the IP address on your host system temporarily to program
the IP address into the DeviceMaster FreeWire. For example: The network
segment must be 192.168.250.x to program the DeviceMaster FreeWire IP address
for your network.
Use this procedure to configure the DeviceMaster FreeWire.
1. If you have not so, install the DeviceMaster FreeWire Installation Setup (Page
14).
2. If necessary, start the DeviceMaster FreeWire Installation Wizard using the
desktop shortcut or Start/Programs/Comtrol/FreeWire/FreeWire Installation
Wizard.
3. Highlight the DeviceMaster FreeWire that you want to configure and click
Continue.
If the DeviceMaster FreeWire that you want to configure does not appear in
the list, click Rescan.
Note: If you have not done so, you must change the IP address on your host to
192.168.250.x so that the DeviceMaster FreeWire Installation Wizard
can communicate with the DeviceMaster FreeWire.