Comtrol DeviceMaster NS-Link - Manual (Page 11)

DeviceMaster Driver User Guide: 2000595 Rev. A Program the IP Address (Network Information) - 11
Before Installing the Comtrol Drivers Management Console
Program the IP Address (Network Information)
If you have not done so, program the IP address for your network. The following
procedure is to program a single DeviceMaster, if you want to program IP
addresses into multiple DeviceMasters, refer to the PortVision DX help system or
the
DeviceMaster Installation and Configuration Guide .
1. If necessary, start PortVision DX, Start > Programs > Comtrol > PortVision DX >
PortVision DX.
2. If the DeviceMaster that you want to program is not displayed, click Scan.
3. Right-click the DeviceMaster in the Device Tree or Device List pane for which
you want to program network information and click Properties.
Note: Optionally, you can double-click the DeviceMaster and PortVision DX
opens the Properties page.