Comtrol DeviceMaster NS-Link - Manual (Page 42)

42 - Configuring COM Port Properties DeviceMaster Driver User Guide: 2000595 Rev. A
NS-Link Device Driver Configuration
4. Select the appropriate communications mode.
Note: The DeviceMaster Serial Hub only supports RS-232. If you select RS-
422 or RS-485 on the DeviceMaster LT, you may want to configure
Terminator Resistor options. If so, click the
Terminator Resistor Options
button.
Make the appropriate selections to reflect your configuration.
5. Enable the features that you require for your environment.
Note: You can use the help system or refer to the following table for
information about each option.