Emerson Radio SMV100 - Manual (Page 20)

19
Radio operation
Note-pressing MODE repeatedly also displays any TIMER ON and TIMER
OFF settings. These are explained on the next page.
Note-Instead of using MEMs and MEMt you can use the number keys on
the remote. In the above example, you would press MEMORY followed by 2.
3. Press MEMORY followed by MEMs or MEMt so that the memory
number flashes to the left of the frequency, for example:
MEMORY CH 02 89. 1 MHz FM. After a few seconds the flashing stops and the
memory number is set.
Note after pressing MEMORY you must enter a memory number within 5
seconds, otherwise the number will not be stored.
Selecting stored radio stations
1. Press BAND to select required band.
2. Press MEMs or MEMt to select required memory number.
Alternatively, you can use the number keys on the remote.
Examples: For memory 7 simply press 7.
For memory 14 press + 10 then 4.
For memory 20 press + 10 twice then 0.
FM mono/stereo
You can set FM radio stations to mono (for example if FM stereo reception is
noisy). To switch between FM mono and stereo, lower the front panel flap
and press FM MONO/STEREO.
Time display
To display the current time, press MODE once.