Emerson Radio SMV100 User Manual
Page 3
IMPORTANT NOTES
Operate controls and switches
as described in the manual.
• Before turning on the power,
make certain that the
connecting cords and power
cord are properly installed.
• When moving the set, be sure
to first disconnect the power
cord and remove cords
connected to other equipment.
Avoid installing this unit in places
exposed to direct sunlight or close
to heat radiating appliances such
as electric heaters, on top of other
stereo equipment that radiates too
much heat, places lacking
ventilation or dusty areas, places
subject to constant vibration and/or
humid or moist areas.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a class
B digital Device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
2