Emerson Radio SMV100 - Manual (Page 27)

9) Loosen the screw until there is a gap about 1/8" between the screw head
and the wall .
10) Position the main unit over the two screw heads so that the heads of the
screws fit into bottom of each "Keyhole" on the back cabinet. When the
two screw heads are inside the keyholes, slide the main unit slightly
downward until each screw head is in the top of the keyhole.
If the main unit is still loose, you probably left too large a gap between the
screw head and the wall. Slide the unit slightly upward and take it off the
mounting screws. Tighten one or both screws slightly and remount the unit. It
should fit snugly against the wall and not move when you are loading or
unloading CD's.
Follow a similar procedure to mount each speaker.
NOTE: It will be necessary to remove the main unit from the wall to connect
the speaker wires. If there is any excess speaker wire hanging
between the main unit and the speakers, remove the speaker from
the wall and push the excess wire into the back of the speaker cabinet,
then remount the speakers.
NOTE: You can also purchase plastic cord covers at most home improvement
centers. These covers can easily be cut to any desired length and
attached to the wall to conceal the speaker wires and AC power cord
if necessary. The covers can also be painted or wall papered to match
the surrounding wall surface.
26
Slide unit downward to lock unit in position Insert screw heads into keyhole
1/8"
GAP