Emerson Radio iC2196 - Manual (Page 6)

Listening to the Radio
1) Press the POWER button to turn the unit
“on”. The POWER indicator comes “on” and
the display will show “ ” few second to
9
OPERATING INSTRUCTIONS
10
• Connect the power cord to your AC outlet. Make sure to use an outlet that is always
‘live’. Do not use an outlet that is controlled by a wall switch.
Antenna Information
AM
The AM ferrite bar antenna is inside
the cabinet. If AM reception is
unsatisfactory try turning the entire
unit slightly until you find the direction
that provides the best reception for
the desired station.
FM
Make sure the FM lead wire antenna
is extended to it’s full length. You may
have to vary the direction of the wire
antenna to find the position that
p r o v i d e s t h e b e s t r e c e p t i o n .
1) While the display is flashing, press and hold
PROG./CLOCK button two second, “ ”
flashing on display to select the clock
format, press SEARCH/SETTING /
button to select 12hr or 24 hr format.
Setting the Time of Day
2) Then press PROG./CLOCK button to enter the clock format, hour digit flashing,
press SEARCH/SETTING / button to set the hour. Be sure to observe the
PM indicator to set the hour correctly. If the PM indicator is “on”, the hour display is
PM.
3) Then press PROG./CLOCK button again to enter the hour and minute digit flashing,
press SEARCH/SETTING / button to set the minute.
4) Press PROG./CLOCK button again to install
the adjusted time.
Setting the wake up time
The unit has two separate wake up alarm that can be set and used independently with
different alarm mode.
1) Press and hold ALARM 1 or ALARM 2 button. The display will change from the
respective time of day to wake up time and hour digit flashing.
2) Press SEARCH/SETTING / button to set the wake up hour. Set correctly
for AM or PM then press respective ALARM button to enter the wake up hour and
minute digit flashing.
3) Press SEARCH/SETTING / button to set the wake up minute then press
respective ALARM button to install the wake up time and display will return to correct
time.
4) Adjust the VOLUME control to desired level.
Playing Compact Discs
Note: Although this CD player can read CD-R and CD-RW discs, in addition to normal
CDs, however the playability of CD-R/RW discs may be affected by the type of software
that was used to create the discs, as well as the quality and condition of the blank
media you are using. 100% playability cannot be guaranteed. This is not an indication
of a problem with the player.
• When the unit is plugged in for the first time
the display will show flashing “ ” (AM).
mention unit in radio mode then display will return to correct time. (as unit default at
radio mode at the beginning, so if the display didn’t show “ ”, press FUNCTION
button cyclic until display show “ ”).
2) Set the BAND selector (on right panel) to AM, FM or FM ST..
3) Turn the TUNING control to find the desired
station, if select in FM ST. band and tune to
a FM stereo station, the FM STEREO
indicator comes “on”.
5) When you want to finish listening, press the POWER button to turn the unit “off”.
The POWER indicator goes “off”.
2008-1-11, 15:49 6