Emerson Radio iC2196 - Manual (Page 9)

2) Set the HOLD switch of your iPod ® to the “Off” position to unlock the clickwheel
navigation controls.
The docking station in this system follows the Apple “Universal Well” design.
This system is supplied with 6 different inserts that can be fitted in the docking station.
One insert serves only as a cover for the docking area to keep the connector free from
dust when no iPod
® will be connected for long periods of time. If you take your
iPod ® on a two-week vacation, place this “cover” in the docking area until you return
and use the system again.
The other 5 inserts are designed for use with any 3rd generation (3G) or 4th generation
(4G) dockable iPod
® model, available as of January 2006, including the iPod Mini
and the 1st generation (1G) iPod ® nano.
If you have either the 30GB or 60GB 5th generation (5G) iPod ® with video capability,
or the 2nd generation (2G) iPod ® nano, use the insert that was included when you
purchased your iPod ® . It will fit properly in the docking station of this system.
If you are using one of the 30GB or 60GB (5G) iPod ® with video capability, or the
(2G) iPod ® nano, use the inserts that were included with the iPod ® when you bought
them.
Press the POWER button to switch the unit
“on”. The POWER indicator comes “on” then
press FUNCTION button cyclic until display
show “ ” few seconds then will return to
the correct time.
After connecting your external device to the LINE IN jack, slowly adjust both the volume
controls on this unit and your external device to find the desired setting. Please NOTE
that if the VOLUME control on this unit is set to a low level while the VOLUME control
on your external device is set too high, the sound will be distorted.
15 16
Play your iPod
1) Select the proper insert for your particular iPod ® model from the “Chart” on page
18 and place the insert in the docking area as shown.
Playing your ‘Dockable’ iPod ®
IMPORTANT
®
3) Place your iPod ® into the insert in the docking area and make sure that it is fully
seated on the connector.
5) Unit will start to play the song in the iPod ® automatically.
4) Press the POWER button to switch the unit “on”.
The POWER indicator comes “on” then press
FUNCTION button cyclic until display show
“ ” few seconds then will return to the
correct time.
6) Use the PLAY/PAUSE, MENU, , and ENTER key to control your iPod ® or
/ key to select your desired song form your iPod.
8) Press POWER button to switch “off” the unit.
7) To stop playback, depress and hold the iPod Play/Pause button until the Pod ®
shuts off.
2008-1-11, 15:49 9