Emerson Radio iC2196 - Manual (Page 7)

4) Display show “ ” and flash while the
player reads the table of contents of the disc
then start to play the disc automatically,
display will show “ ” for a few seconds
then return to the correct time.
11 12
Normal playback
1) Press the POWER button to switch the unit
“on”. The POWER indicator comes on then
press FUNCTION button cyclic until display
show “ ”.
2) Open the CD door by pulling up the ‘OPEN’ on CD door.
NOTE : If the disc is inserted incorrectly or if the
disc is badly scratched and cannot read by the
player, “ ” will appear on the display for a
few seconds then returns to the correct time.
5) To Pause briefly during the playback press
the PLAY/PAUSE button, the Cd track
number flashes briefly and the sound stop,
but the disc continues to spin. Press PLAY/
PAUSE button again to cancel pause and
resume playback.
6) To skip forward or backward to other tracks, repeatedly press the or buttons
until the desired track number appears in the display. Playback will begin on the
selected track.
3) Press or button to select the track to be repeated. The selected track will
be repeated continuously.
Repeat Playback
You can program the player to repeat a single track or the entire disc continuously.
One track repeat
1) Play your disc as normal.
2) Press REPEAT button once, the display will
show “ ” with the current track number for a
few seconds then return to correct time,
REPEAT indicator flashes, the current played
track will repeated playback.
All tracks repeat
2) To cancel repeat playback, press REPEAT button until REPEAT indicator goes “off”
or press STOP button.
1) Press REPEAT button twice, the display will
show “ ” with the current track number for
a few seconds then return to correct time,
REPEAT indicator comes “on”, the entire CD
will repeated playback.
High Speed Music Search
You can search rapidly forward or backward within a track to locate a specific musical
passage.
Depress and hold the or button to begin high speed search. The display will
show the current track and the player moves rapidly forward or backward.
When you reach the desired passage release the or button and normal
playback resumes.
Note: The volume level is automatically reduced during high speed music search.
To Start Playback From A Specific Track
Load your disc to the CD compartment, unit will play automatically after read TOC.
Press the or buttons to select the desired track, playback will jump to the
selected track and continue until the end of the disc.
3) Place your disc on the center spindle with the printed label side facing up and close
the CD door.
7) To stop playback at any time press the STOP button. After the last track has played
the disc stops automatically. Pull up the OPEN to open the CD door and remove
your disc.
2008-1-11, 15:49 7