Classe Audio SSP-300 - Manual (Page 32)

32
• Home returns you to the start-up screen and offers four buttons
(source, video preview, modes, and control). This provides a
quick way to get back to normal operation, regardless of how
deep you might be in the menu system.
• Menu enables you to adjust a number of settings within the SSP-
300 to your own preference.
• Up/Down/Left/Right keys allow you to move within a
particular menu screen, changing the highlighted item up/down/
left/right as you like, from the comfort of your listening position.
• The Enter key allows you to select the highlighted item, having
the same effect as if you had pressed the button on the LCD
touchscreen.
• The Zone key brings up the Zone Control menu on the on-
screen display, allowing you to make changes to the status, source
or the volume of the remote zone.
• The Tape monitor key is not a navigation key, per se, but allows
you to easily toggle between listening to the selected source and
listening to the output of your recording device. If you have
a recording device (such as a three-head tape deck) which can
play back a recording while it is being made, you will be able
to compare the original signal to the recording while you are
making it.
4 Input Selection
These Up and Down arrow keys will cycle through the active inputs on
your SSP-300.
If you have inputs you are not using, we suggest deactivating them in order
to provide faster, easier access to the inputs you are actually using. (See the
section The Menu System for information on how to do this.)
5 F1/F2/F3/F4 keys
F1/F2/F3/F4 keys are available for controlling aspects of the SSP-300
not covered by the other buttons on the remote control. You are able to
choose what the SSP-300 should do in response to receiving the infrared
signal that a particular Fkey has been pressed. The list of possible functions
is quite extensive, and is found in the menu system (see the section The
Menu System, in this manual).
Note: The Fkeys on all Classé remote controls issue the same
infrared commands. This saves you from having to be sure
you have grabbed the proper remote, since all your Classé
remotes will perform the same function for each Fkey.