Classe Audio SSP-300 - Manual (Page 55)

55
For example, if you use the balance control frequently, you may want to consider
programming one of the Fkeys to take you straight to that screen. Doing so will
save you having to access the control menu, followed by pressing the balance
button (which might be hard to see from across the room).
The remote Fkey menu has four buttons, one each for the four Fkeys on your
remote control. Pressing any of these buttons on the LCD touchscreen takes you
to a subordinate, scrolling list of possible functions for that particular Fkey.
Selecting the one you want is as simple as scrolling through the list (by touching
either the up or down arrows on the right), and then touching the specific
function in the list that you want that Fkey to perform.
cautionary note on Fkey use Note that all Classé remote controls provide these same four Fkeys, so that you
need not worry about which remote you happen to pick up. Thus F1 on the
surround processor’s remote control sends the same infrared signal as F1 on the
CD player’s remote control.
While this is intended to minimize confusion amongst different remotes (since
this aspect of them will all perform identically), you should take care when
assigning different functions on different components to the same Fkey. Doing
so would result in two components doing two different things at once, in
response to a single press of a button on the remote control. This can sometimes
be useful. As an example, F1 could set the surround processor to the CD input,
and also set the CD player to Play, both from the press of a single Fkey.
status
The status screen provides several items of information about the current
operation status of the SSP-300, as well as access to information on the software
used in and the internal sensors of the SSP-300.
version info The version info button on the status screen takes you to the version
information screen, which displays information on various pieces of software
used by your SSP-300. If you ever have occasion to call our technical support
people to ask a question not covered in this manual, they may want to know
precisely what version of software your unit is running. Having this information
available will help enable them to give you the best possible service.
sensors The sensors button on the status screen takes you to the sensors screen, which
displays information about several internal sensors within the SSP-300. It is
unlikely you might need the sensor information, unless directed to do so by a
customer service representative at Classé in order to help troubleshoot some
unexpected problem.