Futaba 7C 2.4GHz - Manual (Page 49)

ELEV-FLAP mixing (ACRO):
ELEV-FLAP mixing is the first pre-programmed mix we'll cover. This mix makes the
flaps drop or rise whenever the E
LEVATOR S TICK is moved. It is most commonly used
to make tighter pylon turns or squarer corners in maneuvers. In most cases, the flaps
droop (are lowered) when up elevator is commanded.
Adjustability:
• Rate: -100% (full up flap) to +100 (full down flap), with a default of +50% (one-half of the flap range is achieved
when the E LEVATOR S TICK is pulled to provide full up elevator.)
• Switch: assignable, or null (mix is always active.)
GOAL of EXAMPLE: STEPS: INPUTS:
49
Activate ELEV-FLAP mixing. Adjust
flap travel to 45% flaps.
Set switch assignment to null so the
mix is always active.
Where next?
Open the ELEV-FLAP function.
Activate the function.
Adjust the travels as needed.
(Ex: +45%)
Optional: change S WITCH control. Ex:
change to NULL so flaps only respond
to E
LEVATOR S TICK
input.
Close menu.
for 1 second. (If basic, again.)
to ELEV-FLAP .
to 45%.
to NULL. (--)
Adjust flaperons' flap travel available ( FLAPERON): see p. 42.
Set up AIRBRAKE: see p. 52.
Set up programmable mixes (ex: FLAP-ELEVATOR): see p. 50.
View additional setups on the internet:
www.futaba-rc.com\faq\faq-7c.html.