Futaba 7C 2.4GHz - Manual (Page 55)

GOAL of EXAMPLE: STEPS: INPUTS:
Other Examples:
• RUD-THR(HELI) mix: When right rudder is applied, additional torque is needed from the motor to drive the tail left. Left
rudder requires less torque. A rudder-throttle mix, positive on the left side and negative on the right, adjusts for this.
• RUD-ELEV(ACRO) mix: Compensate for pitching up or down when rudder is applied.
• ELEV-PIT(HELI) mix: Compensate for the loss of lift when tilting the model.
55
Set up a Smoke system:
ON when S WITCH E is in the
down position.
*Adjust the CH7 switch to NULL
prior to this setting. See page. 28.
Where next?
Open an unused programmable mix.
(Ex: use PROG.MIX3.)
Activate the function.
Choose master and slave channels.
Assign S WITCH and position.
(Ex: E DOWN.)
Set rates. (Ex: Lo=100%, Hi=0%.)
Set OFFSET, if needed.
Close menu.
for 1 second. (If basic, again.)
to PROG.MIX3 .
to E DOWN.
to CH3.
T HROTTLE S TICK past center.
T HROTTLE S TICK past center.
Stick to desired point.
for 1 second to set.
View numerous additional mix setups: www.futaba-rc.com\faq\faq-7c.html.
to CH7.
to +100%.
to 0%.