Futaba 8SGAP - Manual (Page 10)

MODE I
Slantable stick adjusting screws
The angle of the stick levers can be changed.
Fig. 3
Turn this screw with a Phillips
screw-driver.
The open gimbal stick
angle can be adjusted from
about 3° to the inside to
4.5° to the outside by
turning the adjusting screw
as shown in the figure.
Adjust the stick to the
most comfortable angle.
Phillips screwdriver
The strength of the stick lever spring can be ad-
justed.
Remove these
screws, and
remove the
back cover.
Fig. 4
Fig. 5-A
Elevator
Rudder Aileron
Turn with a Phillips screwdriver.
The spring strength can be adjusted as desired by
removing the transmitter back cover and turning
the adjusting screw of each stick. Adjust the spring
strength for the best stick feel.
MODEII
Remove the three screws shown and remove the
transmitter righthand side panel as shown in
Fig. 5-B.
Displace the side panel away from the case.
(slide down-off)
Disconnect the power connector.
Adjust the spring tension.
Cautions
• Be sure that the PC board attached to the side
panel does not touch the transmitter case.
• Disconnect the power connector before side
panel completely off, while side down-ward,
to avoid touching with TX case.
•When the power connector is disconnected,
the memorized contents (ATV, FS, etc.) are
cleared. When flying again, reset the contents.
Elevator
Fig. 5-B
The side panel can
be removed by
removing these
three screws.
Aileron Rudder
Power connector
Transmitter RF module
• Change this module when
switching frequency bands
(50, 53, 72, and 75MHz).
A temperature rise at the
RF module section during
use is normal.
Fig. 6
Transmitter
crystal
While pushing this tab to the
inside, pull the RF module forward.