Futaba 8SGAP User Manual

Page 30

Advertising
background image

NOTE:

When lowering lever 8 , be careful that the pitch
does not go negative. This is adjusted during flight.

For example, flight is affected by the temperature,

air pressure, wind, and other conditions. Use this
lever adjusting the speed, pull, etc. to your liking.
Also select the engine tone quality by adjusting

the propeller pitch. Make quiet flights by fine ad-
justing the propeller pitch.

Next, adjust the throttle. First, set switch II to

the OFF position. Adjust the engine idling speed
to 2,200~2,500 rpm with the throttle trim lever

19 . Then set switch II to the ON position and

set the throttle lever to the maximum slow (zero
pitch) position. Adjust idle up lever 9 for an
engine speed of 3000 ~ 4000 rpm. Lever 9 is

inoperative when switch II is in the OFF posi-

tion. Use the variable pitch propeller as an air
brake during dives.

Pitch zero does not have an air braking affect. If
the engine is running at a speed of 3000 ~ 4000
rpm, the air braking effect will not appear if the
propeller diameter is too small.
Adjust the throttle so the pitch is positive and the
engine idles when switch II is set to the OFF
position. Since lever 8 is also operative in this
state, optimum pitch adjustment is possible.

Idle up lever

Operation when switch

is ON

NOTES:

• The pitch always becomes maximum when the

throttle switch is set to HIGH.

•The speed cannot be increased with the idle up

lever 9 when the propeller pitch is zero.

• Since the air braking effect is higher than normal

when landing at zero propeller pitch, be careful
until you become familiar with the setting.

• Best result is often obtained by making the

tuned pipe longer.

Pitch 8-9

Pitch control
high side trimmer

Pitch 11
(maximum)

VARIABLE PITCH PROPELLER AND ENGINE
POWER MATCHING IS ESSENTIAL FOR MAXIMUM PERFORMANCE

If the throttle stick is operated quickly during

flight, the engine will make an abnormal sound

(sputter). If the engine sound remains unnatural,

the pitch control or throttle servo operation tim-

ing can be delayed.

When the throttle lever is suddenly moved from a

high speed to a low speed, the throttle operates
before the propeller pitch changes to zero. If the
throttle lever is moved from HIGH to SLOW, the
pitch will change before the throttle operates.
Set the throttle delay time with trimmer [4] and
the pitch delay time with trimmer [5] . This
provides the same feeling as fixed propeller aircraft
and allows natural flight.

Fig. 55

Advertising