Futaba 8SGAP - Manual (Page 28)

•SERVO TEST FUNCTIONS
• The operation of the servos can be checked by
setting the transmitter and receiver power
switches to ON.
•When switch 49 is switched to TEST-A, the
servos move half-side first and then, come back
to neutral and repeat the other-half from chan-
nel 1 to channel 8. (Channel select switch (R)
48 to TEST-ALL position at this time.) The
servos set by the channel select switch do not
operate. (If set to 5, the landing gear servo does
not operate.)
•When switch 49 is switch to TEST-B, all the
servos operate linearly over their full travel.
(Channel select switch R 48 in TEST-ALL
position at this time.) Only the servos set at the
channel select switch are operated.
• The servo test is started by pressing button [46]]
and is stopped by pressing button 47.
Fig. 48
In this case, set switch [31] to the AUTO ACT
position. Rudder dual rate is then automatically
turned on and off with the throttle stick. Adjust
the throttle stick rudder auto dual rate ON and
OFF positions with trimmer [8].
VTR operation is the same as that for aileron dual
rate and elevator dual rate. Used it as desired.
Fig. 49