Futaba 8SGAP - Manual (Page 13)

•TACHOMETER/TIMER OPERATION
LIQUID CRYSTAL DISPLAY
Do not press the keys too quickly.
Press them at a speed of about once
per second.
|
Do not expose the display to direct sunlight
for a long time.
INTEGRATING TIMER
Blinks during counting
and stops blinking when
counting stops.
UP TIMER
DOWN TIMER
TACHOMETER
Fig. 13
This switch sets the alarm time in the UP TIMER
and DOWN TIMER modes. One minute is set each
time this key is pressed. If it is pressed and held for
two seconds or longer, the time is set in 5 minute
steps.
A beeping signal begins 10 seconds before the dot
time. A beep is produced every minute to indicate
the lapse of time.
This switch is used for memorization, starting,
stopping, and clearing in the UP TIMER and
DOWN TIMER modes. In the INTEGRATING
TIMER mode, this switch acts as the reset switch.
Switches the range when used as a
tachometer. LOW - 100 to 30,000 rpm.
HIGH -100to60,000 rpm
Tachometer/timer power switch.
is displayed at the mode selected at
the MODE SEL key switch
Selects the tachometer/timer mode.
The INTEGRATING TIMER mode is selected and
is displayed when the power is turned on,
The first time this switch is pressed, the UP TIMER
mode is selected and is displayed.
The second time it is pressed, the DOWN TIMER
mode is selected and is displayed.
The third time it is pressed, the TACHOMETER
mode is selected and is displayed.
The fourth time this switch is pressed, the
tachometer/timer returns to the INTEGRATING
is displayed. TIMER mode and