Safety guidelines, Safety warnings, C h a p t e r – Cisco XR 12000 Series User Manual
Page 119
C H A P T E R
3-1
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
OL-17438-04
3
Preparing to Install a Shared Port Adapter or a
SPA Interface Processor
Revised: December 2012, OL-17438-04
This chapter describes the general equipment, safety, and site preparation requirements for installing
SIPs and SPAs. This chapter contains the following sections:
•
•
Preventing Electrostatic Discharge, page 3-3
•
Required Tools and Equipment, page 3-4
Safety Guidelines
Before you perform any procedure in this publication, review the safety guidelines in this section to
avoid injuring yourself or damaging the equipment.
The following guidelines are for your safety and to protect equipment. The guidelines do not include all
hazards. Be alert.
•
•
Electromagnetic Compatibility Regulatory Statements, page 3-2
•
Electrical Equipment Guidelines, page 3-2
•
Telephone Wiring Guidelines, page 3-2
•
Safety Warnings
Note
Review the safety warnings listed in the Regulatory Compliance and Safety Information for Cisco XR
12000 Series Internet Router publication (Document Number 78-4347-xx) that accompanied your router
before installing, configuring, or maintaining a line card.
•
Keep the work area clear and dust free during and after installation. Do not allow dirt or debris to
enter into any laser-based components.