Cisco XR 12000 Series - Manual (Page 93)

2-63
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
OL-17438-04
Chapter 2 Overview: Cisco XR 12000 Series Router Shared Port Adapters
2-Port and 4-Port OC-48/STM-16 POS SPA Overview
2-Port and 4-Port OC-48/STM-16 POS SPA Interface Specifications
The physical layer interface for the 2-Port and 4-Port OC-48/STM-16 POS SPA is Optical Carrier-48
(OC-48), and provides SONET and SDH network connectivity with a per-port bandwidth of 2.488 Gbps.
Each port on the 2-Port and 4-Port OC-48/STM-16 POS SPA has one duplex LC-type receptacle that
allows connection to single-mode optical fiber.
2-Port and 4-Port OC-48/STM-16 POS SPA Cables, Optical Transceiver
Modules, and Connectors
Use single-mode (for intermediate-reach configurations) optical fiber cable to connect your router to a
network or to connect two OC-48-equipped routers back-to-back.
The 2-Port and 4-Port OC-48/STM-16 POS SPA supports the following types of optical transceiver
modules:
• Single-mode short-reach (SR) SFP module—SFP-OC48-SR OC48/STM16c
• Single-mode intermediate-reach (IR) SFP module—SFP-OC48-IR1 OC48/STM16c
• Single-mode long-reach (LR) SFP module—SFP-OC48-LR2 OC48/STM16c
Each port on the 2-Port and 4-Port OC-48/STM-16 POS SPA has one duplex LC-type receptacle. For
single-mode optical fiber connections, you can use either a duplex LC-type cable (see
Figure 2-45 ) or
two simplex LC-type cables, one for transmit (TX) and one for receive (RX).
Figure 2-45 LC-Type Cable
STATUS Off Off SPA power is off.
Green On SPA is ready and operational.
Amber On SPA power is on and good, and the SPA is being
configured.
Table 2-41 2-Port and 4-Port OC-48/STM-16 POS SPA LEDs (continued)
LED Label Color State Meaning
/ / / /
/ /
TX RX
84929