Compatible Systems INTRAPORT 2+ - Manual (Page 29)

Chapter 6 - Basic Configuration Guide 23
2. Set basic IP parameters for Ethernet 0.
Dual Ethernet Single Ethernet
TCP/IP Routing: Ethernet 0
To access this dialog box, select TCP/IP Routing under Ethernet 0 in the
Device View.
A. Click the IP Routing radio button.
B. Enter the internal TCP/IP address you have assigned the
IntraPort 2/2+. Verify that you have the IP Address, the Net-
work IP Subnet Mask and the Network IP Broadcast Mask
correctly entered. Incorrect information can cause difficult to
diagnose problems or disable the IntraPort until the informa-
tion is corrected.
C. If you are using RIP, select the correct version from the Rout-
ing Protocol pull-down menu. If you are not, select None in
the Routing Protocol pull-down menu.
v Note: Routing protocol options, OSPF, and all parameters under the
Options button are advanced configuration parameters and are not
covered here. Refer to the CompatiView Management Software
Reference Manual for more information.
D. Click OK.