Compatible Systems INTRAPORT 2+ - Manual (Page 35)

Chapter 6 - Basic Configuration Guide 29
7. Set up VPN Group Configurations.
VPN Group Configuration: General Tab
To access this dialog box, select VPN Group Configuration in the
Device View.
A. Click on the New... button.
B. Enter a New VPN Group Config Name (e.g. Sales, Account-
ing, etc.) in the pop-up box.
C. Click OK. You are now ready to enter group parameters.
D. On the General Tab:
• Leave the Bind To pull-down menu set to Ethernet 0. You
may change this value later, but that is an advanced con-
figuration parameter and not covered here. The Bind To
specifies which interface on the device will act as the local
end point for tunnels defined by this configuration.
• Choose the Max Connections value and keep this number
in mind. This number is the maximum number of concur-
rent Client sessions allowed in this VPN Group Configu-
ration.
• Set a different Keep Alive Interval or leave the default
value. This is the number of seconds between keep-alive
packets sent to each connected client by the device.
• Set a different Inactivity Timeout or leave the default
value. This is the number of seconds the device will wait