Haltech IG5 - Manual (Page 12)

8
SECTION 1 Getting Started
CHAPTER 1 HALTECH IG5 INSTALLATION
1.1 Overview
The Haltech IG5 system comprises the following components
Haltech Electronic Control Unit (ECU)
Main Wiring Harness
Haltech IG5 system Instruction Manual
Programming Cable
Programming Disk
Relay
Optional Items (at extra cost)
Coolant Temperature Sensor
Inlet Air Temperature Sensor
Throttle Position Sensor (TPS)
Manifold Absolute Pressure (MAP) Sensor, (1,2 or 3 Bar)
Ignition Module
Ignition Timing Trim Control
Reluctor Adaptor - for magnetic triggers
Ignition Coils
Haltech Dual Hall-Effect sensor
1.2 Installation Summary
1. Mount Manifold Absolute Pressure Sensor. (If applicable)
2. Mount Coolant Temperature Sensor. (If applicable)
3. Mount Inlet Air Temperature Sensor. (If applicable)
4. Mount Throttle Position Sensor. (If applicable)
5. Mount Ignition Module
7. Route Main Wiring Harness and connect sensors and ignition module.
8. Mount and connect Power Relay.
9. Mount ECU inside passenger compartment.
10. Locate and connect flying wires:-
RED + 12 volts battery
GREY Ignition on 12 volts
BLACK Chassis ground
11. Install and connect any Optional Outputs
12. Connect Trigger signal
13. Connect ECU and test.