Haltech IG5 - Manual (Page 46)

42
CHAPTER 9 PRINTING MAPS
9.1 The Print Function
You can print the maps and identification information to printers that accept IBM emulation
mode, such as IBM compatible dot matrix, inkjet or laser printers, (consult your printer
manual). The Print function should work with other printers, but some special characters such
as °, ±, etc. may not print correctly. Select the print function by pressing
ππππ
from the Options
sub-menu
The system will present you with options on which data you wish to print. There are four
options. Their meaning is as follows:
1) Setup Information - this will print only the setup pages (ie. Main and Ignition pages).
2) Maps - Prints all the maps in the system (ie. Ignition and Coolant).
3) Output Options - This function will print the current settings and the status of the output
options of the ECU. (ie. Turbo Wastegate).
4) Print All Information - This will print all of the above information
The system will ask for a name to print at the top of the printed output. This allows you to
differentiate between printouts if you have printed more than one set of maps. The name can
be up to ten characters in length. Type in the name and press Enter (
← ← ← ←
).
The system pauses to allow you to set up the printer. If you do not want to print you can leave
the print function by pressing
°°°°
. Pressing any other key starts the printing. Before you start
printing the printer must be Online and must have power and paper. Once the printing has
started you can abort the printing by pressing
°°°°
.