HONDA 2007 Ridgeline - Owner's Manual - Manual (Page 224)

Your vehicle has a class 3 trailer
hitch as standard equipment.
The cover, the ball mount, the hitch
pin, the hitch pin clip, and the jumper
harness are stored in the In-Bed
Trunk.
Also see page for trailer-related
information.
We recommend that you always use
the cover when you are not using the
ball mount to keep dirt, mud, and
snow from clogging the hitch.
To install the cover, slide it into the
opening at the end of the trailer
hitch. To remove the cover, pull it
out and store it in a safe place.
Install the ball mount before you tow
a trailer. Check for and remove
foreign material inside of the trailer
hitch before installing the ball mount.
To install the ball mount, slide it into
the trailer hitch. Line up the holes in
the trailer hitch with the holes in the
ball mount, then insert the hitch pin
into the hole. Secure the hitch pin
with the hitch pin clip.
218
On U.S. RTX model only
Towing a Trailer
Towing Equipment Installing the Cover Installing the Ball Mount
220
TRAILER HITCH
7-PIN TRAILER CONNECTOR
4-PIN TRAILER
CONNECTOR
TRAILER HITCH COVER HITCH PIN
HITCH PIN
CLIP
BALL MOUNT
TRAILER HITCH
Main Menu Table of Contents