Interlogix UltraView ProBridge 2 - Manual (Page 13)

Calibur Kalatel KA2 ProBridge 13 0150-0217B
6 Appendix
6.1 RS-485 Addressing and Connections
The Kalatel ProBridge (CBR-PB2) is not an addressable device
and requires no user settings. The device simply acts as an
interpreter, translating the remote telemetry commands into a
format useable by the P/T/Z controller.
Each camera input, whether a fixed camera or a Pan/Tilt/Zoom (P/T/Z) unit, is
connected to a Calibur unit input. The Calibur unit has an RS-485 network
address, and so does the P/T/Z camera receiver. This address determines
when the telemetry receiver responds to commands sent over the RS-485
data line. Consult the PTZ installation manual for specific instructions on
setting these addresses.
The CBR-PB2-KA2 can be used in conjunction with multiple
Calibur units, multiple Cyberdomes (or Receiver/Drivers) with one
or more keypads controlling the domes and the Calibur units.
Since the ProBridge unit is a terminated device, care should be
used when using this unit in a mixed application. The ProBridge
(CBR-PB2-KA2 must be on the end of the RS-485 line. Please
contact Kalatel Technical Support for design assistance.
The Calibur addresses are set in the range from 1 to 512, as are camera
numbers connected to the Calibur unit. The receiver’s address range is from 0 to
511. The setting of the telemetry receiver’s address can easily be determined
using the following table:
NOTE
NOTE